Stud Finder Stud Detector Bespick Wall Stud Sensor, 4-in-1 Metal AC Wire Stud Wall Detector, Cable Detector Wall Wire Detector Wood Finder, Multi-Scanner for Wall & Ceiling with LCD & Beep Alert

November 7, 2019 - Comment

As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website. Application: Its a certain and necessary tool for every home, if you want mounting a TV, cabinets, frame or DIY your home as whatever you like,

Buy Now on Amazon! £9.99Amazon.co.uk Price
(as of November 21, 2019 11:02 pm GMT+0000 - Details)
As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website.

Application:
Its a certain and necessary tool for every home, if you want mounting a TV, cabinets, frame or DIY your home as whatever you like, you need use this wall scanner to find out AC wire, stud center, and metal behind the wall, so you can drill holes or nails on the wall, avoid danger at the same time.

Specification:
Working Mode: Stud/Deep/Metal/AC
Deep Scan: 1.5inches (38mm)
Stud Scan: 0.75inches (19mm)
Metal Scan: 2.36inches (60mm)
AC Scan: 2inches (51mm)
Power Source: 9V replaceable battery (not included)
Appropriate Working Temperature:32℉~104Fahrenheit
Appropriate Storage Temperature:23℉~113Fahrenheit
Item Weight: 0.32lbs
Item Size: 2.72*1.14*6.3inches

Package Included:
1* Wall stud finder
1* User’s manual

Warm Tips:
1. Please calibration the product firstly before each time you use it, long press the right side button, after a beep to finish Calibration;
2. For stud and deep modes calibration, please place the product on metope surface then calibration, do not calibration it in the air, however for Metal and AC mode, its ok in the air or on the metope surface;
3. If the AC wire is not electrified, the Volt working mode can not detecte it, however the Metal working mode can detecte it becasue inside wire have metal, in this situation, please firstly electrify the AC wire and double check if its AC aire or just metal;
4. Please stick the product tightly to the metope surface all the time during detection, slow move the stud finder across the wall, do not move it very fast, give it a little reaction time;
5. when you use the stud finder, please make sure your wall is dry, if your wall is wet, this has a very bad impact on the test results.

Comments

Comments are disabled for this post.