Description
From the manufacturer
The right saw for your tasks.
Choosing the right saw depends on the size and type of saw teeth, which is appropriate for the task. The tooth size is indicated by the number of full teeth per inch (Tpi = teeth per inch). Large and few teeth give a faster cut. A larger number of smaller teeth gives a fine cut. The following overview shows you which teeth are best suited for your needs.
Construction.
Areas of use: General construction work, carpentry, standwork, beams, planks, coarse cutting. Teeth: Coarse teeth, 7 teeth per inch.
Finishing
Areas of use: Frames, wall and ceiling cladding, floor coverings, laminate and parquet, PVC, fine teeth. 11 teeth per inch.
Special tasks.
Areas of use: Floor coverings, PVC and plastic pipes, plasterboard and drywall elements, aerated concrete. Special saws: With different teeth and tooth sizes for specific tasks
Tips and techniques from the professional.
|
|
|
|
|---|---|---|
Step 1:You can achieve a good cut without tearing out by marking the line with a knife, not with a pencil. Always saw on the bad side (cut side). If you are unsure, leave some space. If necessary, protruding wood can be planed subsequently flat. Align the good side upwards so that splinters or torn areas are covered at the bottom. This is particularly important when working on ceiling or floor coverings, such as laminate. |
Step 2:Start cutting at the edge farthest away from you. Hold the saw at an angle of approx. 30° to the surface. Use the thumb nail of your free hand or a remnant piece to position the cut to the bad side. The first stroke should be more like a light pull to create the cut line (notch). If the saw is correctly in the notch, continue to saw at an angle between 45° and 60° to the surface. |
Step 3:Hold the handle firmly but relaxed. Keep your wrist, elbow and shoulder in line with the saw blade and marked line. You should also keep your head and eyes in line with the cut. Use the whole length of the saw with constant, non-rushing movements. The speed can be increased by lowering the handle once the blade has slipped half through the material on impact. Lower the handle when pulling. Slow down the pace when the saw leaves the marked line. Correct your standing position and carefully try to restore the mark. The saw sound shows you the end of the cut. Support the sawn piece of wood so that it does not fall off uncontrollably. |
Rosemary Woodhouse –
A good little saw, great price
Julie Gillies –
Cuts through wood like butter extremely high quality perfect saw
Amazon Customer –
Great for using. Cuts very well
noonian –
Good accurate saw
Tess Smith –
10 out of 10
Mike –
Very impressed by this saw when I used it to cut some joints that needed to be very accurate. It has a good weight to it, cuts well and is easy to control.
norman strath –
Just what I wanted does the job well sturdy clean cuts
MM –
Recommend the product.It works perfectly, good value.
Dave –
This is larger than my old tenon saw, which is near retirement after 30yrs, and a bit heavier and longer. The thing is razor sharp, so watch a) your fingers, and b) the rate of cut. It cuts at a rate of knots through the roughest of timber.Could do with a proper blade protector, instead of the cardboard sleeve, it wouldn`t have cost much to provide it, my other saws have them.