Trend Craft Pro 1/4″ Shank Straight Router Cutter Bit-Ref:C019X1/4TC Diameter 12mm Cutting Length 19.1mm Tungsten Carbide Tipped Two Flute Dia X

November 3, 2019 - Comment

As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website. Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Cutter has a

Buy Now on Amazon! £12.77Amazon.co.uk Price
(as of 3:09 am GMT+0000 - Details)
As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website.

Suitable for a wide range of applications such as engraving, grooving, rebating and shallow mortising. Use on softwoods, hardwoods, MDF, plywood and chipboard. Cutter has a bottom cut feature.

D: 15/32 inch
D: 12 mm
C: 3/4 inch
C: 19.1 mm
OL: 60
Shank Diameter: 1/4 inch

Shank Diameter: 1/4
Dia Metric: 12
Dia Imperial: 15/32
Cut Length Metric: 19.1
Cut Length Imperial: 3/4
Overall Length Metric: 60

Comments

Anonymous says:

It is a 12mm bit I bought this bit for routing rabbits into 12mm Plywood,unfortunately 12mm Plywood is actually 11.5mm which might not seem a big difference but instead of getting a nice tight friction fit there is a sizeable gap when the wood is entered into the slot. Glue will over come this but its not the best of finishes, all of which is not the fault of the router bit which is exactly what it says it is, ‘a 12mm twin flute router bit’ which is sharp and cuts through wood like a breeze (although how…

Anonymous says:

Very clean cut on Oak Bought this to bachine flats om 38 mm diameter Oak table legs, The cutter cut very smoothly and left a very good finish. On the down side I didn’t see whether the shaft was 1/4″ or 1/2″, Could be me not looking properly, but i expected 1/2″ shaft, turned up with 1/4″. Not a big problem, but could have caught me out if i didn’t have an appropriate sized router collet

Anonymous says:

Shaft snapped on first use. Used this for first time on hardwood, 10mm deep on the 1st pass, with VERY slow rate of advance, using Blue Bosch router.Nice clean cut & no vibration, then about 100mm (4″) from the end of the cut – snap – shaft broke just slightly below the collet.I don’t think Trend are as good as they used to be (probably because they are made in the far east?), trading on a name.Because it’s more than 30 days since purchase from Amazon, you can’t return faulty items – you can sing for…

Comments are disabled for this post.