1/4 Inch Shank Pattern Flush Trim Router Bit with Top and Bottom Bearing Woodworking Tool

November 1, 2019 - Comment

As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website. Specifications: Material: Cemented Carbide Color: As Picture Shown Shank Diameter: 6.35mm (1/4”) Cutting Diameter: 12.7mm (1/2”) Total length: 87mm (3-2/5”) Blade Height: 38mm (1-1/2”) Package Weight:

Buy Now on Amazon! £7.39Amazon.co.uk Price
(as of 2:56 am GMT+0000 - Details)
As an Amazon Affiliate I may make a small commission at no extra cost to you if you purchase the product below or any other product on my website.

Specifications:
Material: Cemented Carbide
Color: As Picture Shown
Shank Diameter: 6.35mm (1/4”)
Cutting Diameter: 12.7mm (1/2”)
Total length: 87mm (3-2/5”)
Blade Height: 38mm (1-1/2”)
Package Weight: Approx. 46g

Package Included:
1 * 1/4″ Shank Router Bit 

Comments

Anonymous says:

Rubbish. Failed after a single use. I used it once to flush trim a worktop. The top bearing just crumbled and all the tiny ball bearings came out. Rendering the bit useless and leaving me with a lovely dink out of my table top. I can not recommend this. Garbage.

Anonymous says:

I should have listened to the earlier unfortunates! Garbage. I foolishly ignored the previous negative feedback on the basis that there wasn’t enough to be sure. Also there appeared to be no alternative product available. A bearing disintegrated within seconds of starting some light trial work on plywood edge. Money down the drain….

Anonymous says:

Don’t buy, it dangerous!!! Needs to be removed from market immediately!!!Just set up my router to trim a few parts and as soon I swiched it on it all went shaking around and almost caused a serious injury!!!

Comments are disabled for this post.